Mouse in the house

[pete's68]

A mouse set up shop in my heater. Does anyone know the easiest way to access the inner workings. It looks like I have to tear the entire dash out to get into the mess.

[wrightz28]

Is this on the '68 in your profile?

Anyway, I find it easiest to remove the blower motor from the engine side and get ithe majority of it out then shop vac it. Get's most of the mess out, the rest if any should just blow out the vents.

[pete's68]

I almost looks like I would have to remove the fender to get the blower cover off?

[wrightz28]

Really? Damn, that's the best and most thurough way to do with out getting nuts. Been a while on that late of a model, but I didn't think it was that close to the right side.

Hmmm, I know the housing is on the right side of the dash if you have to go that route, can't you seperate the blower case by removing the glove box for access?