|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-30-2006, 06:37 PM
|
|||
|
|||
|
No ohmage to 1993 Audi 90s crank shaft positioning sensor
I recently replaced my crank shaft positioning sensor in my Audi. I had my car out for about 4 hours after I replaced it and when I shut it off and started it up again, there was nothing. I checked the fuse on the sensor and that is good, but there is no ohmage going to it. Any ideas as to what I should do or what the problem is?
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
