|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-16-2006, 07:22 PM
|
|||
|
|||
|
input turbine speed codes: 0715, 1740
Hi,new to forum, I'm having a problem with a code for the trans input turbine speed. Is there a sensor that I can change/check?
Last edited by windfart; 05-17-2006 at 06:52 AM. Reason: got correct info that was needed 
|
|
#2
05-16-2006, 09:44 PM
|
|||
|
|||
|
Re: input turbine speed
Transmission Speed Sensor, aka Turbine Speed Sensor (TSS) is located on the side of the tranaxle, right next to where the driver side drive shaft comes out.
The documentation for my '96, it is at about the 11 o'clock position, and held by 1 bolt.
__________________
Moderator for Ford Windstar room only Links to my pictures, intended as an aid, not a replacement for, a good repair manual. 1996 3.8L Windstar http://www.flickr.com/photos/4157486...092975/detail/ 2003 Toyota Sienna pictures (not much there yet) http://www.flickr.com/photos/4157486...781661/detail/
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
