|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-22-2006, 03:47 PM
|
||||
|
||||
Starting Project...NEED HELP
I have a 91 Si and i'm tryin to drop a B16 in. I have Hasport: motor mounts, shift linkage, and wiring sub-harness for the 0BD0 SiR1. I don't know what kinda axles to use. I know that i'm gonna need 91-93 integra axles, but there are a few to choose from. I just don't know which ones. I'll have the YS1 cable tranny.
Also if anyone knows where i can find a complete JDMSIR front end conversion for no more than $650. I can't find a site that has it in stock. Future Plans AEM Hybrid intake DC 4-1 onepiece stainless headers Apexi World Sport exhaust Omni or Skunk2 Test Pipe D2 36-way coil overs JDM Front End, Doors, Wing, Side moldings, Rear Lip PasswordJDM Lip kit Front and Side New Paint ETC. Will be for sell when i'm done!!! I don't plan on racing it, Just till i get a new car.
__________________
"A B16 is a hard working minority - makes the most of it's time and is very efficient. ...While a B18C is a rich lazy ass white guy, who doesn't have much work to do at all - it's all done for him." -Katman 
|
|
#2
04-22-2006, 04:32 PM
|
||||
|
||||
|
Re: Starting Project...NEED HELP
I have 91 Integra non-abs axles in mine..I know they fit because I messed up a cv joint and had to replace it with a new one...When I put it in though, it did rub at first..so we slowly tightened it while turning...turned out there was just a ton of grime behind it, that needed to but scraped out.
__________________
Cheap, Fast, Reliable..Pick two  Current project: Rio Red 91 hatch. A6/Z6 build, Hondata S300, Tokico illumina/Ground Control. "I'd rather run 12's on steelies than 15's on rotas."
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
