|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
||||
|
||||
|
I've got a 2000 Pontiac Grand Prix. I have a leak in my car. It seems to be coming from under the dashboard on the passanger side. If it rains hard, I end up with a lake in the passanger side floor board. Has anyone else had this problem.
|
|
#2
|
||||
|
||||
|
Re: Lake Pontiac....in the passanger floor board of my car...
It is a common problem. The water comes in via the HVAC air intake and drips down the firewall. Check out the passenger side intake cowling seals located by the wipers. Also, if you do not have a cabin air filter installed, installation of one will help maintain a better seal against water and debris. Finally, there is a drain hose in the HVAC assembly to help drain off water and condensation tht may be clogged.
__________________
'08 Pontiac Grand Prix GXP (Dark Slate Metallic) - LS4 5.3L V8 '02 Oldsmobile Alero GL2 - LA1 3400 V6 '99 Buick Regal LS - L36 Series II 3800 V6 '03 Honda CR250R MX - 2 Stroke 250cc '97 Pontiac Grand Prix GTP - L67 Series II 3800 V6 Supercharged (Sold) Timeslip 08/12/06 AF Community Guidelines |
|
#3
|
|||
|
|||
|
Re: Lake Pontiac....in the passanger floor board of my car...
You guys rock!!
I've experienced this as well and now I've got yet another answer, and to think I didn't even ask the question :-) |
|
#4
|
|||
|
|||
|
Re: Lake Pontiac....in the passanger floor board of my car...
The HVAC drain tube is located on passenger side of the firewall and is a black rubber 90 degree boot.
It is a pain to get at on a 3.8L SC motor, but on the 3100 it's easy to get at. I had to remove the strut brace on my parent's Regal to then contort my arm and pull the plug. On my GP I just leaned over the fender and pulled the boot off. If you have a two piece plastic intake cowl, then you're A) Lucky and B) Most likely have a filter in the blower intake. Either way, you should take off the intake cowl and look at the rubber seal That runs along the sheetmetal lip just below the windshield and just above the air intake for the HVAC blower. If that seals is loose, water will seep past it, drop straight down into the housing and get water everywhere. |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|