b16 axles

[shatshadarach]

im putting a b16a5 into a 90 si hatch...its a first gen motor, my tranny sticker was washed away though when they pressure washed it, bastards...so i want to be sure what intermediate shaft i have, so does anyone know the exact length of the possible shafts so i can measure mine up and know????

[90CRXZCSi]

I've never heard of a B16A5 but anyways....if it's the B16A or B16A1 then use the 90-93 Integra axels.

[shatshadarach]

the 5 is the first number in the serial number under the b16a...b16a5's came in the civics...

[91zc]

There is no b16a5. The block is stamped b16a The jdm b16 motors are all stamped b16a with no number after it. As for the axles...I am pretty sure you want to used a 90-93 integra intermediate shaft and axles.

[shatshadarach]

b16a1's dont have a 1 after it either...they are all stamped b16a, the 1,2,3 or 5 come from the first # in the serial # stamped under the b16a...it dont make a diff, just tells you what car it came from...as for my question, i dont need an intermediate shaft, i have one, but i just dont know what one it is, so i would like to know the lengths of the two different intermediate shafts i could have, the one from a teg xsi or a civic/crx sir...

[mellowboy]

Originally posted by shatshadarach
b16a1's dont have a 1 after it either...they are all stamped b16a, the 1,2,3 or 5 come from the first # in the serial # stamped under the b16a...it dont make a diff, just tells you what car it came from...as for my question, i dont need an intermediate shaft, i have one, but i just dont know what one it is, so i would like to know the lengths of the two different intermediate shafts i could have, the one from a teg xsi or a civic/crx sir...

Hey i have the b16 "5 million series" and its off from an integra xsi model and the tranny is a J1. From what i read that the integra xsi model carries that type of tranny. Now about the intermediate shaft..i think they should all fit as long its for the b-series. I'm pretty sure u can though.