check engine light and code 22

[atv087]

car was jerking and stalling etc so i cleaned out the throttle body n pulled off the sensors from it and put it all back together just before and no jerking and stalling that cleared up and it idles smooth now i have a code 22 which is throttle position sensor voltage low. any ideas??

[maxwedge]

Scan it, make sure it is set right. .5 volts at idle.

[atv087]

ok quick question about the tps does it sit on the throttle so when i hit the gas its pushed or does it sit on the other side and have a motor and move to where the throttle by itself?