|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
12-22-2005, 11:20 PM
|
|||
|
|||
|
Code: 1 Oxygen Content
My ECU is flashing a code 1. The engine light comes on for a bit then it goes off again. I was wondering if this means my oxygen sensor is going bad, or it is maybe just not getting enough air. Not sure when last the air filter was changed, so I am going to change that anyways, but was wondering of other reasons for the code 1 if anyone knows of any specific quirks or not. Car is a 1990 Integra GS.
Thanks, 
|
|
#2
12-22-2005, 11:33 PM
|
|||
|
|||
|
Re: Code: 1 Oxygen Content
more than likely, your o2 sensor is gone. test it or swap it.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
