|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
09-09-2005, 04:17 PM
|
|||
|
|||
|
New on this board...
I have a Jeep J10. 360 cid. 4.11 Danas. 4WD. Can I adapt a 5 speed to this engine. Like a T-5. I need some lower rpm's for the highway. Any help would be apreciated.
|
|
#2
09-11-2005, 09:11 PM
|
||||
|
||||
|
Re: New on this board...
Yes, the T-5 was available in the early 80's on some 6 cyl Jeep CJ models, and will fit your V8.
A stock or mildly modified 360 is fine with a t-5. If yours is thoroughly modified, a T-5 will not be strong enough. You may need the matching transfer case, too. If you have a standard trans now, its an easy swap. If you have an auto, you would need to set up a clutch linkage and make sure the rear of the crankshaft had a pilot bushing. This bushing fitting is missing in most auto trans engines, so you need to look for it.
|
|
#3
09-14-2005, 08:19 PM
|
|||
|
|||
|
Hey thanks....So an early 302 t-5. Change the transfer case too?
:smokin:sdsds:smile:
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
