|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
06-30-2005, 07:53 PM
|
|||
|
|||
|
standard swap checklist......
Hey guys and gals,
im doing a standard swap in the very near future and i want to make sure that i have everything i need. so far i got............ -ls tranny -rad -shift linkage -axles -shifter and boot -throwout bearing -clutch -pressure plate -and the pedal assembly if im missing any parts or if you have experience doing this please let me know and dont be afraid to give me a few tips....thanks! 
|
|
#2
06-30-2005, 09:36 PM
|
||||
|
||||
|
Re: standard swap checklist......
well for starters, you should tell us what car this is going into...then you should get the actual motor (you didnt put it on your list.. hehe) third, you should search this site and you will find TONS of info and tips on it.
|
|
#5
07-31-2005, 05:34 AM
|
|||
|
|||
|
Re: standard swap checklist......
search.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
