|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
does anyone know the 1/4 mile time for a stock 95 civic ex with a 170hp b16a2 swap??.........also lookin for 1/4 mile time for a 95 civic ex with a b18c1 swap............stock............thanks
__________________
im doin a hundred on the highway so if u do the speed limit.....get the **** outta my way |
|
#2
|
|||
|
|||
|
Re: 1/4 mile times
Quote:
|
|
#3
|
|||
|
|||
|
Re: 1/4 mile times
id guesstimate low to mid 15s on both blocks on the coupe assuming youve been praticing on the track for a while. if not, the track and street are very different animals.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me. |
|
#4
|
|||
|
|||
|
Re: 1/4 mile times
Since we don't know where you live its hard to give a proper time. But a 2-5 with a b16a2 (by the way if it says b16a2 on the block its usdm and producing 160, if it just says b16a then its 170, jdm motors have no number have the letter, so when you say b16a2, it makes me think of the usdm motor as opposed to the b16 SiR-II jdm) should run a 15 second quarter, being as their heavy...
__________________
'nuff said
|
|
#5
|
|||
|
|||
|
Re: 1/4 mile times
At least in my local area... different elevations also run different times. If I remember correctly, you run quicker at sea level then higher elevations...
__________________
'nuff said
|
|
#6
|
|||
|
|||
|
Re: 1/4 mile times
13-231948639218 seconds, but that's just an average.
__________________
![]()
|
|
#7
|
|||
|
|||
|
e/i you will get to 15 flat
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|