|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-16-2005, 09:43 AM
|
|||
|
|||
|
2000 engine in 95 Contour?
I am trying to put a 2000 4 cylinder engine in a 95 Contour. The 95 engine is about 1 inch shorter than the 2000. Anyone have any experience with this? What else do I need to change to get the 2000 engine in? OR can it be done at all?
|
|
#2
06-16-2005, 12:36 PM
|
||||
|
||||
|
short block or long block?
__________________
 "The CEG Nazi" www.contour.org 1996 Ford Contour SE - Sold 3.0L V6 and Arizona Dyno Chip Turbo Kit 364 whp, 410 wtq @ 16 psi and only 4,700 rpms. 1999 Tropic Green SVT Contour - Bone stock and MINT
|
|
#3
06-16-2005, 01:48 PM
|
||||
|
||||
|
Re: 2000 engine in 95 Contour?
if its a short block i would think just put the 95 head on it and you're set, long block would be a little more difficult. You'd have to swap computers because of VCT. Better off to buy a 95 long block and swap that in
__________________
-Josh- 96' Integra GSR / ITR cams/valvetrain. Skunk2 IM, Greddy evo2, AEM CAI, RMF Header, Megan testpipe, Hasport mounts, Eibach coilovers, Beaks tie bar, Megan H brace, Rota Attacks, F/R strut bar, Kirk 6 point cage, Bride Cugas, Takata 4 Point, ITR Steering wheel 98' SVT Contour, 3L Port-Matched swap with SVT cams/full bolt ons; 224fwhp. 01' Chevy Blazer, DD.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
