|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-27-2005, 12:01 PM
|
|||
|
|||
|
engine mounts
Hi. How do you know 100% that the engine mounts need replacment. The engine has a rough idle in drive and when I stop at lights. RPM is good, just changed the air filter and cleaned MAF sensor ( I thought it would be this ) but the problem is still there. I'm trying to figure out how to check if the mounts are bad. Thanks.
|
|
#2
02-27-2005, 12:20 PM
|
||||
|
||||
|
Take a look at the roll restrictors under the car. You can usually just look at them and see if the rubber within the mount is intact.
__________________
 "The CEG Nazi" www.contour.org 1996 Ford Contour SE - Sold 3.0L V6 and Arizona Dyno Chip Turbo Kit 364 whp, 410 wtq @ 16 psi and only 4,700 rpms. 1999 Tropic Green SVT Contour - Bone stock and MINT
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
