|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-08-2005, 10:45 PM
|
||||
|
||||
|
Duratech
Hey there, just had a question.
I'm trying to find the fuel regulator pressure valve so I can test the fuel pressure. It's a v6 2.5l model. I have a haynes manual, but the haynes manual says its covered by a blue plastic cap. The manual shows it to be by the resonator plenum cover, but thats only in the 4 cyl model... And the only valve I've seen (I believe) is for the air conditioning system. Any help as to the location would be greatly appreciated. 
|
|
#2
02-09-2005, 06:50 AM
|
||||
|
||||
|
go to www.contor.org
__________________
1964 ford falcon 2dr hardtop. 200 inline 6 2003 sporttrac xlt gold 260whp. xcal tune,intake,spacer, and full exhaust system 2008 nissan altima sl bought may 28,2008 gone but not forgotten, 2004 buick rendezvous cx traded. 1997 nissan sentra gxe rip 1998 ford contur se sport 1992 ford excort lx hatchback 1980 chevy scottsdale 350,585 cranck hp 1987 isuzu pup 1964 vw bug
|
|
#3
02-09-2005, 03:23 PM
|
||||
|
||||
|
Re: Duratech
^ It'd help if you spelled it right, www.contour.org
__________________
-Josh- 96' Integra GSR / ITR cams/valvetrain. Skunk2 IM, Greddy evo2, AEM CAI, RMF Header, Megan testpipe, Hasport mounts, Eibach coilovers, Beaks tie bar, Megan H brace, Rota Attacks, F/R strut bar, Kirk 6 point cage, Bride Cugas, Takata 4 Point, ITR Steering wheel 98' SVT Contour, 3L Port-Matched swap with SVT cams/full bolt ons; 224fwhp. 01' Chevy Blazer, DD.
|
|
#5
02-11-2005, 11:24 AM
|
||||
|
||||
|
I guarantee its posted on contour.org somewhere. If its not posted on there, you definetely wont find it on here. About the only thing Ive noticed on here is people post problems, and them people from CEG come over here and post the answers.
 Anyways, here it is where it is. If you look at the lower intake manifold and where the pink rubber cap is, the fuel bleeder valve is located right next to it. It has a black cap, and youll have to unscrew it. Take like a small nail or something and poke it. Fuel should squirt out everywhere. Be sure your car is in accessory mode, so your fuel pump is on. The actual fuel pressure regulator is located right above the barcode.  EDIT: I literally ran a search over on contour.org and found this in 30 seconds. http://www.contour.org/ubbthreads/sh...rue#Post703850
__________________
 "The CEG Nazi" www.contour.org 1996 Ford Contour SE - Sold 3.0L V6 and Arizona Dyno Chip Turbo Kit 364 whp, 410 wtq @ 16 psi and only 4,700 rpms. 1999 Tropic Green SVT Contour - Bone stock and MINT
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
