|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-08-2005, 10:55 PM
|
|||
|
|||
|
Quick Question...
Ok, i got my starter that i needed. Now, my question is how do i bench test it before i put it on?
|
|
#2
02-08-2005, 11:02 PM
|
||||
|
||||
|
Re: Quick Question...
What year and engine and if you just got it whyare you going to test it?
__________________
RIP Hypsi - I just want to express I will never be the same after having lost such a good friend. You meant alot to me and I feel I am a better person for having known you. Til the day we meet again my friend you will always be in my heart. Mods: Weight reduction (I don't wear underwear)
|
|
#3
02-08-2005, 11:06 PM
|
|||
|
|||
|
o yea sry, i was in a hurry...
its a '92 RS w/ a V8 and i bought it from a friend at his impound, it didnt have a starter, i just pulled this one from a '90 model of the same car from Pick n Pull, thats why i want to test it.
|
|
#4
02-08-2005, 11:20 PM
|
|||
|
|||
|
Actually.. should i have to test it at all? or should i just put it on the car and see if it works? (assuming it doesnt take that long...) would it?
|
|
#5
02-08-2005, 11:26 PM
|
||||
|
||||
|
Re: Quick Question...
Install it cause I have never tested one outside a car and most likely it works.
John
__________________
RIP Hypsi - I just want to express I will never be the same after having lost such a good friend. You meant alot to me and I feel I am a better person for having known you. Til the day we meet again my friend you will always be in my heart. Mods: Weight reduction (I don't wear underwear)
|
|
#6
02-08-2005, 11:29 PM
|
|||
|
|||
|
anyone know how long it takes to install one?
|
|
#7
02-08-2005, 11:31 PM
|
||||
|
||||
|
Re: Quick Question...
it shouldnt take too long. i did a starter on an old ford ranger in literally 16 minutes. i can tell you that if you want to test it you should just have to jump a 12volt source and ground to the terminals. if you try it make sure you hold on to the thing...
__________________
 *Better power-to-weight ratio than a C6 corvette*
|
|
#8
02-09-2005, 01:07 AM
|
|||
|
|||
|
haha
well, i just put it on w/out testing it and now i guess i wont know if it works or not until i can get the right resistor into my vats system. (probably tomorrow) that is, if i can figure it out
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
