|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Exterior and Wheels This is the place for all exterior wheel modifcations. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-19-2004, 01:22 PM
|
|||
|
|||
|
condensation in head light!!!
i have taken my passenger head light out twice now to seal it up. i disasembled the light and used cauk, the 2 time i even filled it up with water and to c if it leaked any where and it didnt. i cant figure out how it gets in there. does anyone have any ideas??
|
|
#2
11-19-2004, 10:09 PM
|
||||
|
||||
|
I couldn't find where my Grand Prix headlight was getting water in it either so eventually I just bought a new one. Check for really microscopic cracks on the housing and check that none of the o rings on the bulbs are broken.
__________________
 '99 GSX, 5-speed, 60k miles: Greddy filter / RRE uicp / 1g bov / Autometer boost gauge / Injen-copy intake / Megan DP (not installed) Coming soon! Thx to Blackcrow & nova1313! http://dsm-one.org/ Adopt pets in need!  http://www.petfinder.com/
|
|
#3
11-20-2004, 01:06 AM
|
||||
|
||||
|
Re: condensation in head light!!!
It did that to my car i just left my covers of the bulbs off and it solved it.
__________________
-1997 Eclipse Spyder GST |Stock| -1990 Eclipse GSX |ACL Main & Rod Race Bearings|Balance Shafts Removed|ARP Head Studs|Cometic HG|FP 20g TDO6H|EPROM Chipped (stutter box 5k, fuel comp.)|PTE 680cc inj.|Walbro 255 HP Fuel Pump|Autoteq FPR|SAFC 2|FMIC|2g MAF|Dejon Tool Hard Pipe|Greddy Type S|MBC at 17PSI|Ported 2g Exhaust Manifold|02 Housing w/ Tial 38mm WG|Full 3inch Exhaust w/ Y-pipe Cutout|Fidanza Flywheel|ACT 2100|4 Bolt LSD Rear|Poly Mounts|KYB AGX Suspension|Roll Bar|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
