-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > Isuzu > Rodeo | Passport | MU
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 08-16-2004, 10:09 PM
Marco1980 Marco1980 is offline
AF Newbie
 
Join Date: Aug 2004
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
speed up problem on start

I have 99 Isuzu Rodeo.It takes me too long to speed up .I push the gas harder but it still goes slowly and when it shifts to 2 gear it starts running good with no problems.And when i start going from L and shifting to 2 it runs good.What can be the problem,might be spark plugs???
Reply With Quote
  #2  
Old 08-16-2004, 10:33 PM
amigo-2k amigo-2k is offline
Isuzu Guy
 
Join Date: Jan 2004
Posts: 3,386
Thanks: 2
Thanked 29 Times in 23 Posts
Re: speed up problem on start

sounds like something with the tranny. When is the last time you had the tranny flushed? Is it low on fluid? Keep inmind there is no dipstick. The only other thing is the connections on the shift selector contacts get dirty and need to be cleaned and greased.


faulty range sensor?
I've had a problem with hard shifting on-and-off for over a year. It usually happens only in the morning, and is always after the dash light fails to indicate that the truck is in drive. I had the codes read at a dealer last June, and got back a P0705 code. Is this the range sensor malfunction? If so, any recommendations on what needs to be done and where to get it looked at?


I had the same problem with my 99 Passport. I was able to remove my range sensor, take it apart and clean the contacts inside. I remember it was quite dirty and greasy inside. I think they used too much dielectric grease in it, but the contacts were definitely dirty so I cleaned them reassembled it and I have never had the problem come back. The unit is located on the side of the transmission (drivers side) just forward of center. It's been well over a year since I fixed it, but if I remember right to remove it there was a small metal shield that pops off. Then I had to remove 2 bolts and 1 nut that holds the shifter arm and unplug the wire harness (the wire harness was a little difficult to unplug due to the tight space) and the unit will just slide right out. You will need a torx driver to take apart the unit. I wiped most of the grease out of mine; I left some of the grease there so things will slide properly and to keep moisture out. Depending on how dirty the contacts are you can clean them with a pencil eraser or a very, very fine sand paper. Don't spend the 90+ dollars for a new one this is a fairly easy fix, once you see the inside you won't think it's worth the price tag! It should take you about 45-60 min to repair.
__________________
-Ryan
Isuzu Moderator

Car Show Tips
Operations manager with a results-driven passion for process improvement
FAQ 98-04 Isuzu Rodeo, Rodeo Sport, Amigo, Trooper

SOLD - NOV2015 - 2000 Amigo, V6, HT winter, ST summer, 2wd
Reply With Quote
  #3  
Old 08-17-2004, 03:48 PM
Marco1980 Marco1980 is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Unhappy

I just checked transmissiom fluid,its ok.But it is too hot and burned.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Isuzu > Rodeo | Passport | MU


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:59 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts