-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > Pontiac > Grand AM
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 08-04-2004, 01:48 PM
danjag1 danjag1 is offline
AF Newbie
 
Join Date: Aug 2004
Posts: 17
Thanks: 0
Thanked 0 Times in 0 Posts
94 Grand AM 3100 have spark no fuel spray

Bought an 94 grand am gt V6 3100 with 122k miles, wont start. Have spark, but injectors are not getting ground signal from ECU. Can spray starting fluid into air box, and it will start and run as long as keep spraying fluid in. Injectors are getting 12v, but no ground signal. Put scan tool, generates no codes. Have spare ECU, but same results. Have replaced map sensor. Looking at wiring diagram, unable to determine if cam sensor or crank sensor provide info to ECU for Injector signal. Have replaced bad fuel pump and filter, getting good fuel pressure to injectors. All fuses and grounds are good. Any help appreciated. Past owner said engine was running fine, drove to store, came out, hasnt started since.
Reply With Quote
  #2  
Old 08-05-2004, 09:23 PM
catback23 catback23 is offline
AF Regular
 
Join Date: Aug 2002
Posts: 485
Thanks: 0
Thanked 1 Time in 1 Post
Re: 94 Grand AM 3100 have spark no fuel spray

too little miles to die, without looking at the wiring I can't tell if the ecu proves ground or 12+ for the injectors but I'd check the wire path of the ground to make sure something isn't unplugged or corroded. Crank sensor is for ignition and cam sensor is for fuel for the most part. Dunno if any of this helps but I'd start with tracing the wires, good luck troubleshooting.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Pontiac > Grand AM


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 12:04 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts