Exhaust help on shelby

[GvEman]

Hello as many of you know, i build a custom Shelby series 1 with wide body. Here is the progress thread shelby series 1 thread . And i have decided that the stock exhaust is to small and I want to replace it with another one. And I have another one laying round it comes from the c5-r racing car. So what does you al think of have side pipes that comes out under the door?

[SonyMobile]

Personally, I say no to side pipes, as you have a very low body kit, and adding side pipes would interupt its very flowing style. my suggestion is to scratch build a large rectangular center exit exhaust that comes out the center of the car under the read bumper.

[ProSStreet]

SonyMobile has a good idea. Although i'd like to see pipes like this cobra

I dunno if it will fit the style of the car though

[GvEman]

thanks for your oppinions guys i was thinking of building the exhaustslike tey have on the c5r so you just se the exhaust tips. like this one you se the exhaust tip a bit below the number.

what about that... or should i go with some thing like the stock one..?

[Turbo Monster]

I agree with the idea of the rear exhaust, since it would be more original. I do like the sidepipes, but whatever you think looks best! Square rear-exit would be my favorite! Good Luck!

[GvEman]

thanks m8 for your opinion i might build a exhaust that is almost like the stock one... but i do not think i mka a square... i think i make two chrome ones but with oute muflers and cats and sow one:P

[008]

Since you have a lot of bodywork on there I think the side exhaust would look good. Otherwise it looks "empty" around that area.

Side exhaust = yes. Side pipes = no!

[GvEman]

thanks 008 i think so to... i will lok more at the pipes today and se where the should exit.

thanks again to al of you, for your thoughts!

[sjelic]

or try and make something like this. Exhaust only of course , it is not very visible on this one but main idea is to make a little turete that is cut at some 40 degrese and the pipe is coming out at oposite angle.
[IMG][/IMG]