|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-10-2004, 01:17 PM
|
|||
|
|||
|
1987 Civic Sedan
Hi I am woundering if some one could tell me what motor I can put in my 1987 Honda Civic 4dr Sedan. I know this kind of ? has been asked but it has never been a 4dr sedan. I have the 1.5 in it now and it runs and drives fine but i want more power. It is carb. and the carb is crap. It will not idel and cuts out. So i want to put FI in it but how hard is that going to be. So what i want to do is put a FI motor in it that will bolt right up to my tranny and my motor mounts.
Thanks Alan 
|
|
#2
06-10-2004, 08:48 PM
|
||||
|
||||
|
Re: 1987 Civic Sedan
D16A1, check out the second link in my sig
__________________
~Attention! if you are thinking about a D16A1 swap for your Civic/CRX and don't know where to start go Here. Thanks.~
|
|
#3
06-10-2004, 09:29 PM
|
|||
|
|||
|
thanks i have looked over that thread and i am still a little confused. is the D16A1 the only motor that will fit. and will it be better then the one i have now. or can i just change out the carb. to a weber and get the same power.
Thanks Alan
|
|
#4
06-10-2004, 10:29 PM
|
||||
|
||||
|
Re: 1987 Civic Sedan
check out this thread, that guy just put a weber on his sedan, he keeps up with this forum occasionally as well. the D16A1 is the best bang for your buck in this generation of honda, if you go with anything newer it will require custom mounts.
__________________
~Attention! if you are thinking about a D16A1 swap for your Civic/CRX and don't know where to start go Here. Thanks.~
|
|
#5
06-11-2004, 06:56 AM
|
|||
|
|||
|
ok i think i will just do the swap i can get a hole integra for 700 bucks and that is a running and driveing car. Thanks for the info.
Alan
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
