FS: 1990 chevy SWB c1500 work truck 350,th700r4, locker 30 spline 10 bolt and spares

[richrichmond]

My c1500 143,000 miles work truck model has reached the end of its working life to me. I no longer have the need for my truck. I'm not remoldeling houses anymore and I'm getting out of repairing delapidated cars. So now it sits 27-29 days a month.

The specs:
1990 C1500 base model. Only option auto trans.
Since purchased 5 years ago:

4.3-5.7 flat tappet 2 bolt and required hardware swap.

Engine was reringed with all new bearings, 58cc 1.88, 1.5 inch valves. 9.5:1 compression with dished pistons. Felpro o-ring/rubber gaskets throughout gaskets.

Electric fans, headers, 1 year old 2.5 dual into 3 inch side exit exhaust, trans cooler, new power steering pump, fuel pump, polyeurethane sway bar bushings, motor mounts, tranny mount, good tires, new front carbon metallic pads, tranny drain plug, rear air shocks, new front shocks and alternator

Powertrax EZ-Locker installed 6 months ago.

The truck is in near perfect mechanical condition. Form follows function in my case. The body has some to be desired.

The bad:
The truck is 2 tone front to back. It was originally a stepside but had cracked sides and dented tailgate from a trailer mishap. I replaced it with a standard SWB bed with 2 small dents near the bed rail passenger side and a dented tailgate. Minor rust has developed in 1 cab corner. The truck has a dented driver's doorwhere the previous owner chose to beat the door to close it rather than replace the bushings. The back glass is out due to a engine hoist mishap. Beyond the door, glass, tailgate and paint the body is in very good condition.

1800 OBO

In addition I have a completely rebuilt 5.7 2 bolt main roller with 58cc 1.88, 1.5 roller tipped rocker heads. The engine has new slugs, bearings, gaskets, timing set etc.
$1000 OBO


A complete non intercooled turbocharger kit for a quadrajet carb intake.
$500 OBO

Large journal 327 crank 10/10 undersize with bearings bagged and tagged ready to go in.
$200 OBO

Double Hump 2.02/1.60 valve heads rebuilt with screw in rocker studs and guide plates.
$750 OBO

Please feel free to email or call with any questions at [email protected] or 304.697.5167

Thanks rich