|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-30-2004, 04:23 PM
|
||||
|
||||
|
ECU Question on swap
Just installed a b16a2 with GSR 5 SPD into a 93 coupe that had a d16 in it with 5spd. I added a wire for the knock sensor to pin location d3 on the computer. I am getting no codes but the tach seems to be off now. At 8000rpm its reading 5k. Have I missed something?....What is a good puter for this application?,.....I plan to soon add a whole management system but in the meantime I would prefer for the stuff to work as it should. Odds of the tach being bad?.......I have an autometer tach and shift light I was going to add so maybe install it first and compare to the stock one. My first swap on my first honda.
Photo album Thanks again. E.Honda 
|
|
#2
05-30-2004, 08:56 PM
|
||||
|
||||
|
Re: ECU Question on swap
Stupid question: What ECU are you using?
|
|
#4
05-30-2004, 09:16 PM
|
|||
|
|||
|
Re: ECU Question on swap
i think you meant p28? its the ecu out of your d16z6?
__________________
1993 honda civic si -turbo charged b18c1 dynoed: 316whp at 11lbs
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
