|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#2
10-01-2003, 12:17 AM
|
|||
|
|||
|
Re: S13 project
Quote:
__________________
 NO, it aint my car in the sig, but i like it. so STFU - BIATCH!.  I need to make websites for a college portfolio for graphic/webdesign courses. please hit me up if u need a website and will make a really sweet deal. and my work is guaranteed. 
|
|
#4
10-01-2003, 10:56 AM
|
|||
|
|||
|
ebay has some knock off jdm ones for the rear fenders.... these are probably tour best bet, you can always have the edge rolled, custom make something, or have them put on some fender flares.
|
|
#6
10-01-2003, 08:27 PM
|
|||
|
|||
|
it would be cheaper doing a seperate route. I have seen a R32 front end on a S13 and it was hideous... lines were totally different.
get the rear wide s13 fenders on ebay sometimes or some fender flares, whatever is your taiste.
|
|
#7
10-01-2003, 11:27 PM
|
||||
|
||||
|
I'm wondering if those charge speed front and rear fenders will fit most any body kit or are they made for that specific kit?
__________________
1989 RX-7 TII --- Just got rebuilt and street ported RB 3" dual exhaust, BNR stage 1 modified factory turbo, FCD, S-AFC II, 720cc secondaries, Aftermarket Turbo inlet duct w/K&N, Hawk HP+ pads HKS Blow-Off Valve, Stainless brake and clutch lines
|
|
#8
10-01-2003, 11:40 PM
|
|||
|
|||
|
Re: S13 project
Quote:
__________________
NO, it aint my car in the sig, but i like it. so STFU - BIATCH!. I need to make websites for a college portfolio for graphic/webdesign courses. please hit me up if u need a website and will make a really sweet deal. and my work is guaranteed.
|
| |||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
