How to lower the Integra......simple......just take a look at it.....

[AccordTypeR]

Wassup People?

This post is for the people who don't have any idea that make a car low

down......here is one example with Integra.....just cut the places that

i've marked in color.....but notice that if you lower about 1mm at the

rear suspension you should cut whole 1mm from ony suspension....and

you can cut 0.5mm at the front each from body and suspension....and

the struts.....you have to cut it 1mm....(my Eng. SUX )

anyway......i hope it helps for everyone..... THX

[AccordTypeR]

rear suspensions......

[AccordTypeR]

struts.......remember that you cut these 1mm

[Veyron]

When I lowered my FTO, I just cut away the top 2 or 3 coils off leaving the center post, which lets the strut sink deeper into the mounting hole. This way you can lower it little by little til you get the hight you want, then adjust the rest of the suspension accordingly.

[ZoomZoomMX-5]

If you cut coils off the top, it's easy to drill the top of the coil spring/strut area and replace the locating pin w/a piece of styrene rod or brass, or leave it off so that you can "glue tweak" the final assembly so the wheels fit the wheelwells and sit perfectly level.

[*Cru_Thik*]

this is what i was looking for, thanx so much *AccordTypeR* ....now back to my project.

[turbos86]

pkw1 wrote a thread excatly the same a few months ago, even with the pictures showing excatly the same cutting locations.....

[*Cru_Thik*]

well i didn't hurt to see it again....didn't it

[InTeGrAbOy18]

where was this post last week
damn hahaha finish my type r too i lowered it but did a shitty job

[AccordTypeR]

Originally posted by turbos86
pkw1 wrote a thread excatly the same a few months ago, even with the pictures showing excatly the same cutting locations.....

I didn't even know that he posted or not.....I never copied anyones though......