|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
01-22-2004, 12:09 AM
|
|||
|
|||
|
clearing codes
1997 Town & Country. I have intermittent communication with the car. I have used several scan tools. I ohmed the wires from dlc to ecm. I took pins out of dlc and adjusted them to make better contact (some seemed to be spread a little). I can communicate with car if it has been sitting for awhile. The session may last seconds or minutes but once communication is lost it usually will not reestablish.
|
|
#2
01-23-2004, 08:39 AM
|
|||
|
|||
|
You need an OBD II scanner to clear the codes on these vehicles. Disconnecting the battery, jumping the ALDL connector will not clear codes.
Good Luck.
__________________
NOTHING LIKE AN OLD CAR.
|
|
#3
01-23-2004, 02:34 PM
|
|||
|
|||
|
PCV
That is why I have used several scan tools. The scan tool talks to the PCM. My problem is the scan tools can not talk to the PCM. There is a problem in the car. I changed the PCM with same results. A non dodge dealer mechanic told me a sensor going bad can shut the PCM communication down. I am not getting error code and can not talk to PCM. Surely some one has something say.
|
| ||||||||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
