changing non turbo to a turbo help

[dontbhatin]

I have a 91 eagle talon 2.0 non turbo ,and a 91 mitsubishi eclips 2.0 turbo that has a bad tranny and head gasket. I want to take the turbo and put it in the talon. Can I do this with out to many problems. Here is a list of what I think I need to take, if anything else please tell me. 1 turbo, 2 manifold, 3 front exhaust pipe, 4 intercooler+piping, 5 fule pump,6 fule injecters, 7 spark knock sensor, 8 mass air sensor, 9 engine wiring harness, 10 ecu.

[boots03]

you will also need to have an oil pan,stronger c/v shafts, oil lines, and i belive a bigger exoust, i am thinking about doing the same thing to my 92 talon, and i belive this is all that you forgot. ohh ya, and u will also need i belive a differnt cat.

[boots03]

hell i forgot a really important one, you will also need camshsafts too, the lobs are differnt

[dontbhatin]

Thanks for your help. can I use the cams from the mitsu?

[boots03]

I belive the cams on the talon/laser/eclipse all have the same turbo cams.

[dontbhatin]

thanks I think I'll try it . I'll fallow up when i'm done

[ninety-five-awd]

the easiest way to do this?

don't do it. way to much trouble. you might as well just move the whole motor from the mitsubishi into your talon. you have a good tranny in the talon right? so just do an engien swap. when your done get a new head gasket and your in business. no extreme fabrication really necessary.

[dontbhatin]

the mitsu is an automatic, dont they have a diffrent crank

[boots03]

no, its the same crank, but your car does have the 4G63 in it i belive, so if ya want, just say the hell with it, and replace the head on the engine in the car you want to turbo, just transfer it all over as one unit, thats what one of my buddies did, then he put all the turbo/manifold/piping on last, in my mind, that would be the easiest thing to do

[dontbhatin]

I was thinking the same thing it would be pretty easy that way.