|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-23-2003, 12:53 PM
|
|||
|
|||
|
removing door panel *help asap*
k i think i have all the screws out.. im just stumped on getting the window crank handle off...
__________________
"I just threw away a lifetime of guilt-free sex and floor seats to every sporting event in Madison Square Garden. So, please, a little respect, for I am Costanza, Lord of the Idiots." 
|
|
#2
08-23-2003, 01:29 PM
|
||||
|
||||
|
Just turn the handle so that the knob is pointing up, then look down the back of it. You should see a little wire loop. Just grab on to that with your needle nose pliers and tug up on it. It should just pull off, since it's a spring clip. Then put it back on the handle so you don't lose it. Then, to put the handle back on, leave the clip on the handle (make sure it's in the right position so you can get it off again if you need to) and just push the handle on the gear. If you have any other questions, just email me at [email protected]. Good luck!
__________________
Remember: You can't spell Crap without APC! Classic SE-R GTi-R turbo setup 3" DP U12 modified ECU Hyperco GenII suspension Progress sway SAFC etc. etc.
|
|
#3
08-23-2003, 02:54 PM
|
|||
|
|||
|
thanks a lot
__________________
"I just threw away a lifetime of guilt-free sex and floor seats to every sporting event in Madison Square Garden. So, please, a little respect, for I am Costanza, Lord of the Idiots."
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
