I can't get the brakes on my car to work!

that_one_guy · 04-26-2011, 09:05 PM

1996 cougar
4 wheel disk brakes-ABS

Im having a problem with my brakes

. I can get the front brakes to work but not the back

. The pedal feels like it goes farther down then it should before i stop. i bought new master cylinder, front and rear calipers, proportional valve, and flushed the system

. pedal is hard when i start, but after i bleed the screw it takes 1-2 minutes before i get pressure again

. Pressure will stay and no sign of fluid is leaking except "VERY" small leak on brake line. What could this be??????

Thread Thread Starter Forum Replies Last Post

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can't get Gas Gage to work	Derek44	Problem Diagnosis	1	04-06-2010 10:06 AM
Can't get the brake rotor to come off	vgames33	Engineering/Technical	4	10-26-2008 05:31 PM
I can't get the water pump pulley/casing to seperate from the water pump.	mikev08826	Grand AM	4	03-06-2005 04:00 AM
Speedometer doesn't work.. can't get the pin into hole behind the gauge	90gs	Integra	5	05-20-2003 11:40 AM

GET HEALTHY AFFORDABLE DOG FOOD

DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.

CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.

NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME

PROPER NUTRITION FOR ALL BREEDS & AGES

POST REPLY TO THIS THREAD