Quote:
Originally posted by 4-Door Flunky
I just ran out to the parking lot to look at my car, and my instructions seem even more lame now.
I think I took loose the big bolt ((about 3 or 4 inches long) and the nut that holds it on) that goes from the bottom of the strut to the lower control arm. I also took loose the little nut that attaches the sway bar to the lower control arm. There are also two big bolts and nuts about an inch away from each other, and both of those have to come out.
I don't think it'll actually be 'floppy' like I said earlier, but you should have a little more range of motion to pull the hub down and to the left, and try to move the little piece of axle sticking into the hub the opposite direction, up and to the right.
This mission is highly dangerous. Please print this out, because this post will self-destruct in five seconds.
Flunky
|
k i jst went out there and found the two bolts you said i can only get to one cause the shaft to the axel is right in the way of the second bolt...........i got stopped one more time this is the only stopping me from lifting the block out..........