|
Re: New Starter Will Spin - Won't Engage
That's what I keep resorting back to is that there must be spacing or an alignment issue. I did not notice any shims when I took it out. Just so we're on the same page I am using the old starter and have returned the new one.
There were no corrosion at the terminals on the battery.
I have cleaned all connections at the battery, fuse panel, and the starter. Seems to have a great connection.
Yes I have a full 11/12 volts still while key is in on position and I have the same on the solenoid connector when cranking.
I have not been able to find the ground cable from the block though. Do you know where it is?
|