|
Its very simple
1. Disconnect the wiring connectors
2. Disconnect spark plug wires
3. Remove 3 hold down bolts - 10mm i think
4. Always replace the o-ring if removing or replacing distrib.
5. Slide distrib in - it can onlt be seated properly 1 way
6. Reverse the process but do not over tighten distrib. bolts
7. Set timing & then tighten hold down bolts to 16 lb ft which isnt much
8. There is way to remove distrib with out having to set the timing - scribe a mark across the distrib & the head. This does not apply to replacment
|