hello, some minor update here,
rear bumper, plastic plate added to support the PE muffler grill for easy glue on later.
test fit the PE.
plastic plate added to support the rear grill aswell. here is the question, this is the 1st time i have to glue a PE grill directly on the face of the body instead of glue it from the inside like other common grill. which way should i do? glue it 1st, then mask the PE and paint the body, remove the mask from the PE and mask the body then paint the PE? or do all the paintjob and finishing then only stick on the PE last? to me, i think the 2nd option carry higher risk of damaging the paint job if somthing bad happen like too much CA glue or accidentally chip the paint when glue the PE.
test fit the PE.
scribe some panel line on the door to bring out more detail.
Dig the hole of the lock on the door. PE rivet will be add on after paint to bring out the detail.
thats all for now, hope fellow modeller here can guide me on the PE grill. thanks for your time. all comment are welcome.
