LIM gasket
Pages :
1 [2]
597GTP
04-30-2009, 06:06 PM
thanks for all the help guys, I wouldn't of done it with out your help!!!!
Anyway, tblake good luck on them GM aluminum gaskets, they didnt work for me . What I noticed was that , the gasket didnt meet up with the valley/edge gasket very good. Felpro's fit like a glove!
Hopefully they wont leak this time.
Well talk to you guys soon.
Anyway, tblake good luck on them GM aluminum gaskets, they didnt work for me . What I noticed was that , the gasket didnt meet up with the valley/edge gasket very good. Felpro's fit like a glove!
Hopefully they wont leak this time.
Well talk to you guys soon.
BNaylor
04-30-2009, 07:15 PM
School of hard knocks. I recall recommending using the FelPro gaskets only. There are many anecdotal failures reported on the revised GM aluminum framed LIM gaskets.
tblake
04-30-2009, 08:11 PM
Ahhh, now you guys tell me. HA HA!
Just finished mine up. No issues, I snapped pictures which I will post in a bit.
Only thing was when I first started it, it ran terrible and the SES light was flashing. I plugged in my scanner and it came back with a P0300. Quick glance at my coil packes and I realized I mixed up plug wires 2 and 4. OOPS! (IDIOT!) Once swapped, it rann exceptional.
Just finished mine up. No issues, I snapped pictures which I will post in a bit.
Only thing was when I first started it, it ran terrible and the SES light was flashing. I plugged in my scanner and it came back with a P0300. Quick glance at my coil packes and I realized I mixed up plug wires 2 and 4. OOPS! (IDIOT!) Once swapped, it rann exceptional.
doctorhrdware
04-30-2009, 08:50 PM
That is another 10 demerit points. :evillol::naughty:
BNaylor
04-30-2009, 08:55 PM
That is another 10 demerit points. :evillol::naughty:
:werd:
:evillol:
:werd:
:evillol:
tblake
04-30-2009, 09:40 PM
Bob should had demoted me by now for all my retarded remarks.
Like that one thread where a member was some sort of problem. In the original post he stated that he had is LIM gaskets and UIM changed a few months prior.
I posted a reply and asked if he had a 3800SC or 3800NA.
Rich called me out and Bob dang near banned me. I had to plead with him to keep my advisor status. I'm still greatfull, thanks Bob!
Here's some pics I took of my LIM gasket replacement...
http://www.automotiveforums.com/vbulletin/showthread.php?p=5963415#post5963415
Like that one thread where a member was some sort of problem. In the original post he stated that he had is LIM gaskets and UIM changed a few months prior.
I posted a reply and asked if he had a 3800SC or 3800NA.
Rich called me out and Bob dang near banned me. I had to plead with him to keep my advisor status. I'm still greatfull, thanks Bob!
Here's some pics I took of my LIM gasket replacement...
http://www.automotiveforums.com/vbulletin/showthread.php?p=5963415#post5963415
Automotive Network, Inc., Copyright ©2026
