2001 3.8 oil pan question

Hi All, I have a small rust spot on the front of the oil pan that I am told could become an issue if it progresses. Has anyone ran into this and should I investigate an epoxy solution or just bite the bullet and replace the pan? Also, is it a major undertaking to replace the pan or can it be done without too much trouble? Thank you

Pan replacment can be a big job.
What type of vechicle?
Epoxy works wonders.
Most 3.8 pans rust

2001 Impala police pkg

Mitchell labor 4.8hrs
Must raise engine.
So if not rusted to bad try epoxy for awile.

For what it's worth I had this problem with my 92 Lumina 3.1. 70k I wire brushed it then cleaned with a degreaser. I then prepped it with Permatex* rust treatment 2 coats. Let sit for 24 hrs, sand lightly w/320 grit clean with alcohol then topcoat with desired color. Lasted at least 6 years, 144k I then sold the car 2 1/2 years ago....may still be good for all I know still see it around town occasionally. This is not an endorsment for the product mentioned, I am sure there are others out there just as good or perhaps better. Best of luck on your choice of fix....

it really is not that bad and a wire brush is exactly what I thought to hit it with initially. I appreciate the suggestion.

just clean it up.... some pans though you can get out without much trouble