Re: Cam sensor code

i am working on a 95 buick that is doing similar things the cam error and the cam signal cirrcit. i have tested everything but still i have not gotten it to run right. we have put in a new cam sensor, crank sensor, PCM, and a ICM. it still comes back to the same code PO431 and PO342 and i have visualy and with a DMM check the wires and the links to the cam and the crank. if you have any idea what is going on i could use the help.
thank you.

Have you checked the cam gear magnet on your car?
Cam magnet replacement (http://6007.us/cammag.htm)

BTW: Welcome to AF! If you will notice, I started this new thread for you using your post in an older thread. The following links will help you better understand how AF works. Thank you in advance for your cooperation.
Posting in closed or outdated threads - LeSabre (http://www.automotiveforums.com/vbulletin/showthread.php?t=635166)
Community Guidelines (http://www.automotiveforums.com/vbulletin/guidelines.html)
Search Forums (http://www.automotiveforums.com/vbulletin/search.php)
Post New Thread - LeSabre (http://www.automotiveforums.com/vbulletin/newthread.php?do=newthread&f=102)


(http://6007.us/cammag.htm)

thank you and i hope i can bring some knoledge to the table.

i looked to see if the magnet was there. the magnet is in one pice and still magnitized.
i just took it out for a road test and i am still geting the codes but i am not getting any cam errors trough gennises.
i have gone back and looked at all the wiring and the 8 pin plug that is under the passenger side carpet.
that was clean as a wistel.
i realy dont know what to think on this.

Looks like either a wiring problem or your down to trying a new ECM.

Good Luck