BMW Z8 Fitment Problems

I'm working on a Revell BMW Z8 right now. When I put the assembled interior into the body it doesnt fit well. When I take out the dashboard of the assembled interior and put the interior into the body (minus the dashboard), it fits perfect. i think the dashboard is interferring with something on the body, or when in place, pushes the door panels outward. Has anyone encountered this?

I didn't made this model. but this sound like usually Revell problem. Try to see where exactly it don't fit, and sand down that part until it fit.

I didn't made this model. but this sound like usually Revell problem. Try to see where exactly it don't fit, and sand down that part until it fit.

Lets hope he hasn't paint these parts yet..!!

yeah, its not just you, there is alot of fitment problems with this kit... as i remember i think i installed the doors, then attached the body and finially squeezed in the dash... good luck

I believe now there are two areas that need to be trimmed. First, the dashboard along the windshield base and secondly, where the door panels meet the dashboard. I trimmed this areas last night and it fits better.

Lets hope he hasn't paint these parts yet..!!

If so, then repaint.. It's not that hard :lol:

Here's mine for you to have a reference

http://www.automotiveforums.com/vbulletin/showthread.php?t=420285

yes there is fitment is a problem on this kit.... you have to trim the stud which used to align the rear wheel a bit. Tha's the major area that makes the car doesn't align right. For the dash, u have to use some pretty violent force to push the shell into the dash.... during the process, make sure the interior panel is inside the shell...

I have lowered the Z8 for about 3mm