Programming remote (FOB) for 2004 Toyota Solara

I tried to program a new remote for my 2004 Solara using the closest instructions I could find.. 2000-2003 Camary.. it seemed to be going well, all of the things that were supposed to happen ("doors locks will automatically cycle 3 times"...etc) except the final step... door locks should cycle... nothing happened... not only was I unable to set my new remote, but my existing one no longer works... Any help would be greatly appreciated.. John

Wrong forum buddy

Wrong forum buddy
I need say nothing except BLazerLT move him to his correct rice paddy

I need say nothing except BLazerLT move him to his correct rice paddy
LMFAO! :bananasmi

I thought there was a place on this board where this was to be put i wanted to put the link up for him but i cant find it.

http://www.geocities.com/toyota_speed2003/


or


http://www.automotiveforums.com/vbulletin/t172063.html


that one there seems popular

Sequoia 01 - 03
Camry 00 - 01
4Runner 99 - 04
Sienna 99 - 03
Solara 99 - 05

1. Start with the following conditions: you are seated in the vehicle
a. Key is out of the ignition.
b. Drivers door is open, all other doors are closed.
c. Drivers door is unlocked.
2. Insert the key into the ignition (don't turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. cycle the power locks 5 times, evenly spaced and relatively fast.
b. Close, then open the drivers door.
4. Perform these steps within 40 seconds:
a. cycle the power door locks 5 times. (Same as before)
b. Turn the ignition to on, then back to off.
c. Turn the ignition to on, then back to off.
d. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle (automatically) indicating successful entry into programming mode. Return to STEP 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.
b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once indicating successful programming. If the door locks don't cycle, or cycle twice, repeat steps 6a and 6b - this remote has not been accepted.
c. Repeat steps 6a and 6b for each transmitter that will operate this vehicle, including any old transmitters.
7. Close the driver door.

From that thread on how to do it

I used this on my 2006 and it worked but not all of the sequence were quite the same no beep to notify that you were in program mode but it was and followed seperate remote seq, to add them
and step 7 the door should already be closed as per instructions