It's alive!!!!

Man what a different sound than the old HF, i got a little bit of a high idle but i can get that straightned out i think, but turned out the timing was 180 degrees out, swaped it around and bam, fired right up w/ a smooth idle, like i said it was a little high but it didn't bounce or anything. Thank sgod for the sound of that motor cause i was starting to get worried!!

congrats, so what motor did you put in there ?

d15 vtec, just curious man, where would you start on the idle. Will the crank angle sensor if it is not set cause it to idle high, and plus i have the hf accel. cable on there, but i have the z6 one on the way.

first make sure hte throttle cable isnt too tight cause it to pull hte throttle open just alitle causing a higher idle. if its loose then turn the idle screw down and it should drop your idle. i just did this today on my dpfi because it was idling high

Congrtas on getting it all done.I just got the rest of my parts in yesteday so I will be swapping mine out next weekend.

so i was right :)
good to see u got it sorted out man :)

first make sure hte throttle cable isnt too tight cause it to pull hte throttle open just alitle causing a higher idle. if its loose then turn the idle screw down and it should drop your idle. i just did this today on my dpfi because it was idling high


YEAH WHAT HE SAID.