fenders not lining up

well i bought some VIS Z3 fenders and for some reason there not lining up like they should and ideas? they say 88 crx on the fender but would that matter if there going on a 90 crx

Hmmm...... Cheap aftermarket fenders not lining up.. Get used to it.

(I didn't mean cheap in reference to the cost because I'm sure they were expensive, but quality rather)

yeah it does matter it they are 88 fenders goin a a 90, the 90 & 91 crx bodys change a little in a few areas front (bumpers & ect.)

Are you SURE they are VIS??? I've never had a problem with VIS stuff before. Do they have the VIS label on them.

change in body style form 88 to 90

yea they do...www.jtrsport.com bought them form that site listed...

Most after market pieces that are mass produced aren't going to be perfect. I tried installing Z3 fenders on my buddies Integra a couple of years ago and it looked HORRID!! The hood barely closed. As someone stated before, get used to it. That's just the nature of fibreglass parts.

88-91 the fenders are the same.. At least they are on hatches, I don't see why CRX would be different.

I'm pretty sure just the bumpers are different between the years.

i thought they were different between 88-89 and 90-91 on hatches ?

No. I have an 88 fender on my 91 and fits a lot better than my aftermarket made-in-korea fender on the other side of the car. It was $50cdn. new and I couldn't resist a new fender for that.. haha..

i stand corrected

88-89 and 90-91 crx fenders are different in how the corners bolt up. Other than that, they are the same.
So, you said your aftermarket fenders aren't lining up properly? Welcome to the world of aftermarket mofications!

do you have to get the corrosponding years corner lenses to get them to work?

well, you could make anything work if you wanted to. But, if you are using 88-89 fenders on a 90-91 crx, and wanted to use the 88-89 corners, you'de be ok. But if you did the opposite, 90-91 fenders on an 88-89, you'd have to drill holes for the screws.

lol thanks bam bam do you guys recommend me letting a body hsop lining them up and putting them on? cause i got the vis ones hoping they line up easy but there not as easy as i thought