soild red light

ecu is throwing a solid red light i think that its code zero which is faulity ECU .....when i start it up it will run fine then when i take it to like 3 grand the check engine light turns on and the ecu light turns on and the motor will cut out at 3 grand i can drive it with the light on but i can rev past 3 grand it looses ALL power

you just think i should try and find a new computer or is there something i can check to fix the problem

i have tried to reset the ecu about 4 times and still the same problem

Anyone have an idea??

thanks for the help

-Chris-

check your grounds. had something similiar happen after we did a swap. it turned out to be a loose ground. if you check and all seems good then i would check the ecu.

checked the grounds and everythings good i hear a tick everytime it happens when the check engine light comes on for down by the fuse box you think it could be an main relay going bad

Anyone have an other suggestions

Thanks

how would i tell that my main relay is bad and where is it located i kno its under the dash but i cant find it


Anyone have help? i think it might be causing the problem above^^ i can here it ticking everytime the check engine light one.....

ANYONE?

Its located behind the drivers side kick panel. The location and how to test it are both in helms

http://www.binghamtonlife.com/manual/2gsm/default.htm

This does not sound like a main relay problem.

i tried a different ecu and a different dizzy and still has the same problem anyone have any other ideas of what it is im going to check the main relay today

i have no idea what it is.....