This sux

What the hell do I do if I get water in my spark plug holes? My plugs come out all wet, and i know its water so what do i do?

I put this in lets get technical forum, but i figured id put it here too

Are you using your stock spark plug wires cause they tend to warp and not fit the spark plug holes really good with a suction. Just a thought

ya, im using those wires rite now, i just dont know if theres a way to get the water out

you could take the plugs out and turn the motor over and it should spit it out...

my friend just had that happen and I forget what he did to get it out...i'll ask him

uh... how much water is in there before you do that^^ Try a turkey baster:dunno:

wet/dry vac!

if all else fails, use a straw and put your finger over the end like you do getting pop out of a glass :P

how the fuck did water get in there? I imagine if water sat in there long enough it would leak past the rings and mix with the oil. I would drain out all of the oil and let it drain for a long time, take off the oil pan and drain it out make sure there is no oil in there mixed w/ water... new gasket and put it back on then start ur engine. If u think about it, unless u started ur engine the only places for the water to get to would be from they cylinders down to the bottom of the block and oil pan so right there u would be eliminating all of your water problems. If there was just a little water it probably wouldnt do anything if it just sat on the cylinders... they have water injection it would be doing essentially the same thing just raising ur compression temporarily.