need help bad with b16A1 swap

ok i have a 89 civic si with a b16a1 swap and for about a year now the car has not been started...i first had to buy a new ecu (PR3) and new distributor (T22du) and new shift linkage...well when i put those parts on the car was turning over but i realized i wasn't getting any fuel...so i went and borrowed a rz0063 relay to test the fuel pump...when i plugged it in i could tell the relay was turning on but this time the engine wouldn't even crank...so i was just wondering if anyone could help me before i load up the car and take it to some garage where they will charge my life for a $5 peice...thanx for anyones help

Is your ecu throw'n any codes? Look at that first before anything.

i don't believe it is...is there any place on the internet for a free shop manual...that way i can tell what codes it is showing if any...

Online manual for 88-91 civic: http://www.binghamtonlife.com/manual/2gsm/

Code Descriptions:
Code 1 (1 flash) Oxygen content

Code 3 or 5 Manifold absolute pressure

Code 4 (4 flashes) Crank angle sensor

Code 6 (6 flashes) Coolant temperature

Code 7 (7 flashes) Throttle angle

Code 8 (8 flashes) TDC position (top dead center) timing

Code 9 (9 flashes) No. 1 cylinder position (1.6L)

Code 10 (10 flashes) Intake air temperature

Code 12(12 flashes) No code 11 don't know why. Exhaust gas recirculation system

Code 13 (13 flashes) Atmospheric pressure

Code 14 (14 flashes) Electronic air control (EACV)

Code 15 (15 flashes) Ignition output signal

Code 16 (16 flashes) Fuel injector

Code 17 (17flashes) Vehicle speed sensor

Code 19 (19 flashes) No code 18 for some reason Lock up control solenoid valve

Code 20 (20 flashes) Electric Load

pr3 uses long and short flashes long=10 and short =1
http://honda-tech.com/zerothread?id=468260
that may help if u r showing codes