[Need Help] Problem after ZC Swap

Hey Friends,

I have the following Problems with my 4th Gen Civic DX

I Swaped a D16Z5 CRX (EDM) 1.6l DOHC MPFI Engine into my 90' Civic ED6 (90HP D15B2 DPFI)

I use the PM7 ZC ECU an a complete ZC engine. I followed the DPFI to MPFI Guide to install the missing wires.

But the engine has the following probs:

The red Oil Preassure Warning Light is on all the time.

The orange Engine Warning turns on when I start the Engine.

The Engine has 4000 U/min when turned on. (and not the normal 1500 when I start a cold engine)

ECU says: Code 9: Cyl. Sensor ?!

But I'm sure I installed the wires for the Cyl. Sensor (blue/geen & blue/yellow) correct?! (Pins C1 & C2 @ ECU)

Anyone knows Help?



[Sorry for my bad english, i'm from germany]

well my pm6 ecu has said code nine since i did my install but then my zc isnt running right now, if i may ask you? do you have a ecu pinout chart showing positions c1 & c2?

Sorry,

as I said my english is not very good. So could you please explain to me what a "ecu pinout chart" is?

Perhaps this could help you?! -> http://www.fourthgenhatch.com/mpfi.html

Arne