engine installation

when i'm putting the engine in, should i attach the side mount first or put it in level?

always attatch the rear mount first , then the passanger side and the driver side will fall right into place

ok so to attach the rear first, i'd have to go almost level? b/c i was told a 30-45 degree angle. if anyone could help detail thsi process for me i'd be very appreciative, i need it in tomorrow, no if ands or buts about it.

I did the side mounts first, then the rear than the front.

what angle do i doit at? i'm out there now and its just not going in, i keep wedging up on hte crank pulley...

yeah i did the sides then the front and rear

and try putting it at more of an angle untill the tranny is in the scoot it over

ITS IN :biggrin: all we did was take the side tranny mount off and it gave alot of space for us... of course i think i lost a motor mount bolt, i had three that were basically the same just slightly difference lengths and one that was about 1/2 inch longer than the rest, didn't know which it coulda gone for so we just got some locking washers and spaced it out... but its in, just gotta wire it up and listen to the smooth purr of my RActive exhaust :)