Uniwiper

What would it take to go back to normal wipers from the uniwiper? Is it something that's hard to do? What's needed, etc

Wipers Removed fot weight reduction.

nah, jus kidding, i took mine off cuz i think the car looks cleaner without them.

Winshield Rain-X-affied.:bigthumb:

All you need is a 10mm wrench and the other wiper, then all you do is losen and adjust the other one to where it just covers the passenger side like it is suppose to. It is very simple, it shouldn't take you more then 5 or 10 min to figure it out.

Why, trying to get your car into Max Power???


LOL, just kidding.....Just use the longer wiper on the other side.

Basically, the wipers are held on by a spline post, so in order to convert from a uniwiper to a regular setup, just remove the 10mm nuts from the wiper posts, pull the uniwiper off, then put it back on at the correct angle. The splines will keep it lined up. Then just add the other wiper at the same angle, put the nuts back on and you're good to go. Don't tighten the nuts tooo hard though.

Thanks alot folks. I knew that I could count on you all for info.:bigthumb: