quick question guys

Im puttin the mpfi swap on my dx 1.5... I want to swap the entire harness in but i know it doesnt mount right up so can i just run the wires that neeed to be run from the ecu and tap them into the harness????

i have done EVERYTHING with wiring in my car, most important, what harness are you swapping in? cause putting an SI harness WILL NOT WORK, NOT EVEN WITH THE CABIN ONE TOO.

Originally posted by 2000dollarZCbs
i have done EVERYTHING with wiring in my car, most important, what harness are you swapping in? cause putting an SI harness WILL NOT WORK, NOT EVEN WITH THE CABIN ONE TOO.

its kinda true. i used an SI engine harness, the interconnect plugs from an SI body harness, and the interconnect plugs from my STD engine harness. i used the interconnect plugs to make a subharness. its the easiest thing, cause now i can unplug my motor from a few plugs, and pull out. theres no direct wires to the ECU, which means no cutting them if you ever have to pull the motor, or no unplugging every damned sensor like on nissans.

it was from an si so what im going to do is make a harness out my dx might take alil longer but i think it shouldnt be that hard....Thanks guys if i need ya ill post again.....

an si harness will most definately work, but it is a pain in the ass to change over the entire car wiring harness.

so the way im doing it by tapping into my dx harness Basically creating my own harness is the best way?

its defiantely the quickest/easiest way.