2000 SW2 wheel bearing
xdanx25
07-11-2011, 07:18 PM
just curious as how to replace it, or if its the same as the 98 version
speediva
07-11-2011, 09:21 PM
Welcome to AF for starters!
I'm afraid I don't know much about this model, so I can't be of assistance, but hopefully someone with more expertise can share!
I'm afraid I don't know much about this model, so I can't be of assistance, but hopefully someone with more expertise can share!
Ruley73
07-13-2011, 01:41 AM
just curious as how to replace it, or if its the same as the 98 version
It is the same as any 1998 or any 1991-2002 S-Series for that matter.
It is more difficult than most cars because the bearing and hub (two separate parts) need to be pressed off/on with a hydraulic press or with an appropriate hub puller. The hub gets pressed out of the bearing first then the bearing gets pressed out of the steering knuckle. There is a large snap ring on the inner side of the bearing holding it in place, so don't forget to remove that before trying to press it out of the steering knuckle.
For installation, the new bearing must be pressed into the steering knuckle first, then the hub gets pressed into the bearing. You can reuse the hub unless you see an obvious reason to replace it.
It is the same as any 1998 or any 1991-2002 S-Series for that matter.
It is more difficult than most cars because the bearing and hub (two separate parts) need to be pressed off/on with a hydraulic press or with an appropriate hub puller. The hub gets pressed out of the bearing first then the bearing gets pressed out of the steering knuckle. There is a large snap ring on the inner side of the bearing holding it in place, so don't forget to remove that before trying to press it out of the steering knuckle.
For installation, the new bearing must be pressed into the steering knuckle first, then the hub gets pressed into the bearing. You can reuse the hub unless you see an obvious reason to replace it.
Automotive Network, Inc., Copyright ©2026