Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Cutlass Series Includes Cutlass Ciera, Cutlass Cruiser, Cutlass Calais, Cutlass Supreme, Custom Cruiser, as well as the GM N-Body subforums. |
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
03-29-2010, 01:03 PM | #1 | |
AF Newbie
Join Date: Mar 2010
Location: St. Joseph, Missouri
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
93 Cutlass Ciera 3.1L V-6..........
Daughter bought the car, guy told her it had a bad maf. Replaced it and exhaust. Still ran erratic when first taking off, once up to speed ran fine. Died one day like it was out of gas. Couldnt get it to restart. Have replaced fuel pump, fuel filter, maf, crankshaft sensor,coil packs check out good, plugs and wires replaced, oil changed. Starts and idles good, once car idles for a few minutes and warms up runs erratic, sputters around and dies. Can hook up fuel pressure guage, can hear new pump kick on, car starts, pulls 40 lbs. on guage, as car warms drops to 30 lbs., starts to sputter around. Continues to drop on guage and dies. Can cycle key on and car starts again will 40 lbs. of pressure and repeats the whole dying process!! No codes on engine, have had 2 mechs look at it, and they are shaking and scratching their heads!!
Any ideas? Would pull my hair out BUT it is already gone!!!! Guys thanks in advance!!!! |
|
03-29-2010, 07:25 PM | #2 | |
A990 racer
Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,954
Thanks: 25
Thanked 371 Times in 365 Posts
|
Re: 93 Cutlass Ciera 3.1L V-6..........
It will not run at 30 psi fp, pump or blocked fuel filter. BTw, there is a filter on the end of the pick up in the tank, I ssume that was also replaced?
__________________
|
|
03-29-2010, 11:50 PM | #3 | |
AF Newbie
Thread starter
Join Date: Mar 2010
Location: St. Joseph, Missouri
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 93 Cutlass Ciera 3.1L V-6..........
That was my point, the car will not maintain the proper pressure of 40 lbs. Yes the filter was changed at the pickup. My question that i am seeking an answer for is why it will not maintain the proper pressure.
|
|
03-30-2010, 08:53 AM | #4 | |
A990 racer
Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,954
Thanks: 25
Thanked 371 Times in 365 Posts
|
Re: 93 Cutlass Ciera 3.1L V-6..........
OK, pinch off the return line from the FP regulator see what happens. Basic stuff.
__________________
|
|
06-17-2010, 07:13 PM | #5 | |
AF Newbie
Join Date: Jun 2010
Location: pottsville, Pennsylvania
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 93 Cutlass Ciera 3.1L V-6..........
did you try replace the converter
|
|
|
POST REPLY TO THIS THREAD |
|
|