 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
08-25-2012, 03:03 PM
|
#1 | |
|
AF Newbie
Join Date: Dec 2005
Location: springfield, Ohio
Posts: 45
Thanks: 0
Thanked 0 Times in 0 Posts
|
101 code after changing intake gaskets
2001 fire bird with 3.8 non super charged. I changed the upper and lower intake gaskets. Once put back together cars coughs and runs rough at idle and sometime surges and climbs rpms. I keep getting the po101 code. I checked for vacuum leaks. Firing order, all connections and any and every other thing I could think of without tearing the intake back off.
I'm wondering if I missed a ground or something. No codes till after the gasket replacement. I'm at a loss on this one I checked egr and vacuum lines. Pulled the plug o. The maf while car was running and there was no change. Any suggestions would be greatly appreciated before I pull the intake and start over. |
|
|
|
|
08-25-2012, 08:58 PM
|
#2 | |
|
AF Fanatic
Join Date: Jul 2011
Location: Worcester, Massachusetts
Posts: 5,017
Thanks: 70
Thanked 618 Times in 610 Posts
|
Re: 101 code after changing intake gaskets
Did you remove the PCV valve in the upper plenum and forget to install the black and orange orings?
|
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
