94 Isuzu engine swap with 4.3

[okiekid55]

Rookie here! Looking for anyone that has swapped a Chev 4.3 into a pick up not a chevy clone Hombre. Especially motor mounts or procedures done before. I have searched other sites but none with how to do it. Links to other forums or sites would be helpful. I have a 4.3 block with Vortec heads and 700R4 tranny. I am wanting to go with a carb setup. Don't like computers. Appreciate any and all assistance.

[amigo-2k]

check out stinkfab.com

if your truck came with a 2.8, your options for a swap is a 3.1 or a 3.4. The 4.3 is entirely different.

[okiekid55]

No, it has a carbed (Weber) 2.3 w/ 5 speed and 4.10 rear. Wanting more hp to fool around with.

[CanadianRanger]

i am curious about the same kinda thing. i have a 94 with a 3.2l 4x4,a nd i was wondering if i could squeeze a 4.3l vortec gm engine in there, if anyone know if this is possibleand what issues i might have, ie tranny, motor mounts radiator etc. Thanks in advance

[okiekid55]

Canadianranger,

From what I have searched/surfed on, it is possible to mount a 4.3 or even a sbc in an Isuzu with no cutting required. I just have not found anywhere or anyone that has posted the "how to do it". Good luck.

[CanadianRanger]

thanks, if ya do happen to find anything about it, itd be great if ya could post it, im definitely tempted to do it.
but i like you havent found anything about it yet

[mjohn]

Need a motor for a 92 Isuzo pickup truck...
The 4cyl engine gave up the ghost and the body is good...
is it worth fixing?